DavidPoz
Solar Thermal Tank Insulation and Liner

Solar Thermal Tank Insulation and Liner

By David Poz·

With the tank frame built, the next step was insulation and waterproofing. Inside the tank, we installed Polyiso foam insulation board in two layers, each two inches thick, giving us an R-26 rating on the walls. The insulation was leftover stock from the house build — nothing went to waste.

The tank floor sits on the existing crawlspace insulation, also rated R-26. Between the walls and floor, this tank is wrapped in a serious thermal blanket.

For waterproofing, we lined the interior with EPDM rubber — the same material used for pond liners. We carefully folded the corners and stapled the top edge to the wooden frame. EPDM is durable, food-safe for this application, and creates a reliable watertight seal.

The combination of thick insulation and rubber lining gives us a thermally efficient, leak-proof vessel ready for the heat exchanger and solar collector connection. Next up: installing the PEX heat exchanger coil inside the tank.

Ready to Cut Your Energy Bills?

Book a consultation to get a personalized plan for your home.

Schedule a Consultation